Apple Processor Cage and Clips Guía de instalación Pagina 76

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 117
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 75
Figure 50 Generating SP ID Page
NOTE: During the SP Setup process, the StoreServ must be powered on, connected to the
same network subnet as the SP, and non-initialized to allow the SP to verify the StoreServ
serial number.
3. After the SP ID is generated, click Next.
Configure SP Networking
To complete this section, use the completed installation checklist from HP 3PAR StoreServ 7000
Site Planning Manual as reference.
NOTE: For additional information and help, use the HP 3PAR SmartStart online help (accessible
by pressing F1).
1. Enter the SP information for the following fields:
Service Processor hostname
IP Address
Subnet Mask
Gateway
76 Setting Up the Service Processor and Storage System
Vista de pagina 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 116 117

Comentarios a estos manuales

Sin comentarios