Apple Processor Cage and Clips Guía de instalación descargar pdf (Pagina 37)

6. Repeat steps 1 through 5 for the other rail.

7. Check both sides at the front and back of the rack to ensure all screws are installed properly.

Mounting a 4U rail shelf onto the rack

1. Verify each directional-specific rail matches with the side of a rack post.

The following text is imprinted on both ends of the rails: FRONT-R and FRONT-L.

2. Align one end of the rail channel with the holes of the rack post, and then push to seat the

locating pins in the rack.

3. Expand the rail to connect to the other end of rack post.

4. Secure the front and rear of the rail assembly to the rack post using four T25 Torx shoulder

screws (two in front, two in back) in the top and bottom holes. Tighten the shoulder screws

with a torque of 19 in-lbs.

5. Install the middle support bracket before transporting:

a. Align the middle support bracket holes with the top holes of the rail(s). The orientation of

the middle support bracket is neutral.

b. Insert and tighten screws.

Figure 19 Installing the Middle Support Bracket

6. Repeat steps 1 through 5 for the other rail.

7. Snap one cage nut into the rack hole two positions above the rail on both sides.

Installing the Rail Kit 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 116 117

Sin comentarios

Apple Processor Cage and Clips Guía de instalación Pagina 37