Apple Processor Cage and Clips Guía de instalación descargar pdf (Pagina 15)

Controller Node PCIe Slots and Ports

Table 1 (page 15) describes default configurations for the HP 3PAR StoreServ 7000 Storage

system:

Table 1 Storage System Expansion Cards

Nodes 2 and 3Nodes 0 and 1Expansion cards

No expansion card1 FC HBA each2 FC HBAs only

No expansion card1 10 Gb/s CNA each2 10 Gb/s converged network

adapter (CNA) only

1 10 Gb/s CNA each1 FC HBA each2 FC HBAs + 2 10 Gb/s CNAs

The following expansion cards are supported:

• 4–port 8G FC HBA

• 2–port 16G FC HBA

• 2–port 10G CNA

• 2–port 10G Ethernet NIC

• 4–port 1G NIC

NOTE: If you are upgrading from a two-node to a four-node configuration, you can have CNAs

installed in node 0 and node 1, and FC HBAs installed in node 2 and node 3.

Figure 5 (page 15) shows the ports on a controller node.

Figure 5 Location of Controller Node Ports

1 2 3 4

Table 2 Controller Node Ports

PortItem

2 Ethernet

MGMT--Used to connect to the storage array management interfaces

RC--Used to connect to Remote Copy

Fibre Channel (FC-1 and FC-2)--used to connect to host systems2

SAS (DP-2 and DP-1)--used with SAS cables to connect to the drive enclosures

and I/O modules

Understanding Component Numbering 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 116 117

Sin comentarios

Apple Processor Cage and Clips Guía de instalación Pagina 15