
Welcome Page
The Welcome page shows the information that is required to complete the wizard and set up the
SP. Follow the instructions on each screen, and then click Next.
The setup takes about 15 minutes.
You must have the following information:
• StoreServ 7-digit serial number
• SP network configuration:
The name to be assigned to the Service Processor◦
◦ IP address (IPv4 only)
◦ Subnet mask and gateway, if you are using custom settings
◦ DNS settings, if you plan to enable the Domain Name System
• Remote support:
◦ Proxy server settings (optional)
• Time and region:
The current date and time or NTP server addresses, if you plan to use automatic date/time
configuration
◦
◦ Time zone region (for example, America/Los Angeles)
Figure 48 Welcome Page
74 Setting Up the Service Processor and Storage System
Comentarios a estos manuales