Apple AIRPORTCARD - Airport Networking Network Card Información técnica descargar pdf (Pagina 50)

Solution

Make sure your LAN card is installed properly and set up for TCP/IP. See the

instructions that came with your LAN card.

The Printer Not Found screen appears during installation

Cause

The HP all-in-one is not turned on.

Solution

Look at the color graphics display on HP all-in-one. If the color graphics display is

blank and the light next to the On button is not lit, the HP all-in-one is turned off.

Make sure the power cord is firmly connected to the HP all-in-one and plugged into a

power outlet. Press the On button to turn on the HP all-in-one.

Cause

You do not have an active network connection.

Solution

Make sure you have an active network connection. For more information, see You

do not have an active network connection.

Cause

Cables are not connected properly.

Solution

Check the following cables to ensure they are connected properly:

● Power cords to the HP all-in-one and the router

● Cables between the router and your computer

● Cables to and from your modem or HP all-in-one Internet connection (if

applicable)

I am using a cable modem without a router and I do not have IP addresses

Cause

If you have a PC with a cable modem, a separate Local Area Network (LAN) for

your other computers, and no DHCP or router, you must use AutoIP to assign IP

addresses to the other computers and to the HP all-in-one.

Solution

To obtain an IP address for the PC with the cable modem

➔

Your Internet Service Provider (ISP) assigns either a static or dynamic IP

address to the PC with the cable modem.

HP all-in-one Network Guide 47

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 61 62

Sin comentarios

Apple AIRPORTCARD - Airport Networking Network Card Información técnica Pagina 50