Apple AIRPORTCARD - Airport Networking Network Card Información técnica descargar pdf (Pagina 42)

Solution

Add encryption security to your network. For information, see Add security to the

network.

Cause

Your SSID or WEP key might be set incorrectly.

Solution

You can use either the Embedded Web Server or the control panel to change the

SSID or WEP.

To use the control panel

1 On the control panel of the HP all-in-one, press the Setup button.

2 Press 8, and then press 4.

This displays the Network menu and then selects Wireless Setup Wizard.

3 Press

to highlight your network, and then press OK.

4 When prompted, use the visual keyboard to enter the new Network Name and

WEP key.

5 Complete the Wireless Setup Wizard.

To use the Embedded Web Server

1 With an Ethernet cable attached, print a network configuration page. For

information, see Print and view a network configuration page.

2 Make sure the network SSID and WEP key shown on the configuration page

match those used on your wireless network.

3 If one or both are incorrect, enter either the URL or device IP address from the

configuration page into the Address box on your Web browser. For example,

http://195.168.0.5.

The HP all-in-one Embedded Web Server Home page appears.

4 Click the Networking tab.

5 In the Connections navigation menu, click Wireless.

6 Click Start Wizard.

7 Enter the correct values in the appropriate sections (Network Name and

Encryption).

8 Click Apply.

Cause

You are using an authentication protocol not supported by the installation

software.

Solution

Use one of the supported protocol types listed in the Embedded Web Server.

Types not supported include: WPA2-AES, WPA2-TKIP, LEAP, PEAP, EAP-MD5,

EAP-TLS, or EAP-TTLS.

HP all-in-one Network Guide 39

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

Sin comentarios

Apple AIRPORTCARD - Airport Networking Network Card Información técnica Pagina 42