Apple Xserve (Early 2008) DIY Procedure for Thermal Grea Manual de usuario descargar pdf (Pagina 12)

Xserve (Late 2006/Early 2008) Thermal Grease Kit Instructions 12

Replacing the Processor Heat Sinks

Important: Before re-installing each heat sink, be sure to clean o any existing thermal grease

from the underside of the heat sink.

Holding the heat sink by the slotted sides in one hand, reconnect the 2-pin thermal sensor 1.

cable for the heat sink to the logic board.

Note: Make sure the connector on the sensor cable is oriented as shown, with the gold

ngers facing up.

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the 2.

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated 3.

below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8

inch-pounds; otherwise, try to tighten the screws with equal pressure.

Repeat the steps above for the second heat sink.4.

1 2 ... 7 8 9 10 11 12 13 14

Sin comentarios

Apple Xserve (Early 2008) DIY Procedure for Thermal Grea Manual de usuario Pagina 12