Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Manual de usuario

 Xserve (Late 2006)073-1112 Rev. ARear ID TabReplacement InstructionsFollow the instructions in this document carefully. Failure to follow these inst

Xserve (Late 2006) Rear ID Tab Replacement Instructions 10Disconnect the optical drive cable from the logic board.Release the two locking levers on t

Xserve (Late 2006) Rear ID Tab Replacement Instructions 11Release the nine thumbscrews that secure the logic board to the enclosure (highlighted in t

Xserve (Late 2006) Rear ID Tab Replacement Instructions 12Rear ID TabNote: The rear ID tab protrudes from the rear panel through a slot.Locate the re

Xserve (Late 2006) Rear ID Tab Replacement Instructions 13Gently grasp the ID tab and pull up on it to disengage it from the channel that it slides a

Xserve (Late 2006) Rear ID Tab Replacement Instructions 14Installing the Replacement Rear ID TabInsert the replacement rear ID tab through its slot i

Xserve (Late 2006) Rear ID Tab Replacement Instructions 15Clean o any existing thermal grease on the left (CPU B) processor heat sink using the alco

Xserve (Late 2006) Rear ID Tab Replacement Instructions 16Clean o any existing thermal grease on the top face of the processor using the alcohol wip

Xserve (Late 2006) Rear ID Tab Replacement Instructions 17Use the edge of the package that the alcohol wipes came in as a spatula to smoothly spread

Xserve (Late 2006) Rear ID Tab Replacement Instructions 18Rotate the top of the holder to the closed position.Engage the latch on the metal processor

Xserve (Late 2006) Rear ID Tab Replacement Instructions 19Tighten the four captive Phillips mounting screws for the left processor heat sink in the o

Xserve (Late 2006) Rear ID Tab Replacement Instructions 2Removing the Xserve from a RackAlert users that the server will be unavailable for a period

Xserve (Late 2006) Rear ID Tab Replacement Instructions 20Replacing the Fan ArrayAlign the power connector on the fan array with its connector on the

Xserve (Late 2006) Rear ID Tab Replacement Instructions 21Tighten the ve Phillips screws that fasten the airow duct to the fan array, in the order

Xserve (Late 2006) Rear ID Tab Replacement Instructions 22Replacing the Power SuppliesSlide the rst power supply all the way into the bay, and then

Xserve (Late 2006) Rear ID Tab Replacement Instructions 3Opening the XserveLoosen the thumbscrews at the back of the top cover and slide the cover ba

Xserve (Late 2006) Rear ID Tab Replacement Instructions 4PCI Riser Cards and Expansion CardsLoosen the two captive screws that secure the riser brack

Xserve (Late 2006) Rear ID Tab Replacement Instructions 5Airow DuctLoosen the ve Phillips screws that fasten the airow duct to the fan array.Pull

Xserve (Late 2006) Rear ID Tab Replacement Instructions 6Fan ArrayLoosen the two thumbscrews that secure the fan array to the enclosure. Note: The th

Xserve (Late 2006) Rear ID Tab Replacement Instructions 7Note: You may encounter some resistance around the fan array power connector during removal.

Xserve (Late 2006) Rear ID Tab Replacement Instructions 8Disconnect the backplane-to-logic board cable from the drive interconnect backplane and remo

Xserve (Late 2006) Rear ID Tab Replacement Instructions 9Important: Each heat sink is connected to the logic board by a small 2-pin thermal sensor ca