Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Manual de usuario descargar pdf (Pagina 14)

Xserve (Late 2006) Rear ID Tab Replacement Instructions 14

Installing the Replacement Rear ID Tab

Insert the replacement rear ID tab through its slot in the rear panel. Make sure the tab engages

with the channel that it slides along in the enclosure.

Replacing the Logic Board

Important: When replacing the logic board, make sure the board’s rear port connectors t

through the appropriate openings in the Xserve’s back panel. Take special care to t the rear ID

button through its opening. Don’t bend or ex the logic board.

With the front edge of the board raised 1–2 inches (3–5 cm), guide the connectors on the

back edge of the board into the openings in the back panel of the enclosure, and then lower

the front edge of the board into place.

Use a screwdriver to tighten the nine thumbscrews snuggly, but don’t overtighten.

Slide the power distribution board back into place and tighten the thumbscrew.

Note: Make sure the edge connector on the power distribution board goes completely into

the connector on the logic board. If the power distribution board doesn’t slide easily, make

sure the thumbscrew is popped up so it doesn’t catch on the mounting post beneath the

board.

Reconnect the front panel board cable and the optical drive cable to the logic board.

Replacing the Processor Heat Sinks

Note: You will need to clean o the old thermal grease from the bottom of each heat sink and

the top of each processor. You will then need to apply new thermal grease to the top of each

processor, before re-installing the heat sink onto the processor.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Manual de usuario Pagina 14