Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual de usuario descargar pdf (Pagina 42)

Xserve (Late 2006/Early 2008) Backplane-to-Logic Board Cable Instructions 3

Removing the Installed Backplane-to-Logic Board Cable

Note: Before removing the backplane-to-logic board cable, you must remove the airow duct.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

Caution: Try not to completely remove the screws from the airow duct. Tiny black rubber

washers hold these screws captive on the underside of the airow duct. If the screws are

completely removed, these washers can easily fall into the enclosure and become lost.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 168 169

Sin comentarios

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual de usuario Pagina 42