Apple Xserve Intel (Late 2006) DIY Procedure for Process Manual de usuario descargar pdf (Pagina 5)

Xserve (Late 2006) Processor Replacement Instructions 5

Important: Each heat sink is connected to the logic board by a small 2-pin thermal sensor

cable. Be careful not to pull on the wire as you lift each heat sink enough to disconnect the

cable from the logic board.

Slowly lift the heat sink o the processor just far enough that you can reach the sensor cable

connector. You might feel some resistance from the thermal grease that binds the heat sink

to the processor.

Pull on the connector, not the wires, to disconnect the sensor cable from the logic board.

Lift the heat sink straight up and out of the enclosure.

Using the alcohol wipe that came with the replacement processor, clean o any thermal

grease from the underside of the heat sink. Save the alcohol wipe package for later.

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Apple Xserve Intel (Late 2006) DIY Procedure for Process Manual de usuario Pagina 5