Apple Xserve (Early 2008) DIY Procedure for Power Distri Manual de usuario Pagina 3

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 2
Xserve (Late 2006/Early 2008) Power Distribution Board Cable Replacement Instructions 3
Removing the Installed Power Distribution Board Cable
Locate the power distribution board cable. 1.
Caution:2. The power distribution board cable connectors are tight and can be dicult
to disconnect. You may want to use small atblade screwdriver to gently yet rmly pry
outwards on the cable connector while depressing the cable connector latch with your
thumb and forenger to separate the connectors.
Disconnect the cable from its connector on the drive interconnect backplane.
Disconnect the other end of the cable from the power distribution board and remove the 3.
cable from the Xserve.
Vista de pagina 2
1 2 3 4

Comentarios a estos manuales

Sin comentarios