Apple Xserve Intel (Late 2006) DIY Procedure for Optical Manual de usuario descargar pdf

073-0778 Rev. B



Xserve/Xserve G5

Optical Drive

Replacement Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Online instructions are available at http://www.info.apple.com/installparts/.

Note:

These instructions apply to the optical drive of different versions of Xserve/Xserve

G5. Your server may look slightly different from the one shown in the illustrations.

Tools Required

The only tool required for this procedure is a jeweler’s Phillips (#0) screwdriver.

Opening the Server

The server slides open from the front of the rack. The top cover remains in place in the

rack while the bottom housing (containing all internal components) should be placed on a

sturdy, ﬂat surface.

1. Alert users that the server will be unavailable for a period of time.

2. Shut down the server.

Warning: To avoid damaging internal components or causing injury, always

shut down the server before opening it. After you shut down the server, internal

components can be very hot. Let the server cool down before continuing.

3. Write down the server’s serial number, which is located on the back panel. If it is

necessary to set up the server’s software after you replace the optical drive, you will

be asked for the serial number at login.

1 2 3 4 5 6

Optical Drive 1
Closing the Server 6

Indice de contenidos

Pagina 1 - Optical Drive

073-0778 Rev. B  Xserve/Xserve G5 Optical Drive Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these

Pagina 2

Xserve/Xserve G5 Optical Drive - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key

Pagina 3

Xserve/Xserve G5 Optical Drive - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure

Pagina 4

Xserve/Xserve G5 Optical Drive - 4 Removing the Installed Optical Drive 1. Disconnect the optical drive cable from the optical drive. (Figure 3) 2.

Pagina 5

Xserve/Xserve G5 Optical Drive - 5 Installing the Replacement Optical Drive Note: Before installing the replacement optical drive, you must transfe

Pagina 6 - Closing the Server

Xserve/Xserve G5 Optical Drive - 6 Closing the Server 1. Carefully slide the bottom housing back into the rack.2. Tighten the front thumb screws to

Mas documentos para Software Apple Xserve Intel (Late 2006) DIY Procedure for Optical

a Ver el documento Apple Xserve Intel (Late 2006) DIY Procedure for Optical Manual de usuario

Apple Xserve Intel (Late 2006) DIY Procedure for Optical Manual de usuario (7 paginas)

Comentarios a estos manuales

Sin comentarios

Apple Xserve Intel (Late 2006) DIY Procedure for Optical Manual de usuario

Busca en linea o descarga Manual de usuario para Software Apple Xserve Intel (Late 2006) DIY Procedure for Optical. Apple Xserve Intel (Late 2006) DIY Procedure for Optical Drive Cable User Manual Manual de usuario

Indice de contenidos

Mas documentos para Software Apple Xserve Intel (Late 2006) DIY Procedure for Optical

Comentarios a estos manuales

Relacionado con productos y manuales para Software Apple Xserve Intel (Late 2006) DIY Procedure for Optical