Apple Xserve (Early 2008) DIY Procedure for Power Distri Manual de usuario descargar pdf (Pagina 5)

Xserve (Late 2006/Early 2008) Power Distribution Board Replacement Instructions 5

Caution: The power distribution board cable connectors are tight and can be dicult to

disconnect. You may want to use a small atblade screwdriver to gently yet rmly pry outwards

on the cable connector while depressing the cable connector latch with your thumb and

forenger to separate the connectors.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

Caution: Try not to completely remove the screws from the airow duct. Tiny black rubber

washers hold these screws captive on the underside of the airow duct. If the screws are

completely removed, these washers can easily fall into the enclosure and become lost.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Sin comentarios

Apple Xserve (Early 2008) DIY Procedure for Power Distri Manual de usuario Pagina 5