Apple Xserve (Early 2008) DIY Procedure for Logic Board Manual de usuario descargar pdf (Pagina 4)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 4

Power Supplies

Pull the handle to release the rst power supply and slide it out of the bay. 1.

Pull the handle to unlatch the

power supply and remove it.

Repeat for the second power supply, if installed.2.

PCI Riser Cards and Expansion Cards

Loosen the two captive screws that secure the riser bracket in slot 1 to the back panel.1.

Carefully pull up on the bracket and riser, with the expansion card still attached, to 2.

disconnect the riser from the logic board.

Captive screws

Tilt the expansion card up so that its port clears the enclosure, and remove the card from the 3.

Xserve.

Repeat for the riser card in slot 2. 4.

Note: If no risers are installed, remove the blanks held in place by the same screws.

1 2 3 4 5 6 7 8 9 ... 30 31

Sin comentarios

Apple Xserve (Early 2008) DIY Procedure for Logic Board Manual de usuario Pagina 4