Apple Xserve (Early 2008) Manual de usuario descargar pdf (Pagina 15)

Chapter 1

Installing the Xserve

If you have a square-hole rack, start with the rail flanges inside the posts and expand

the rail between the front and rear posts until the small round guide on each flange

extends through the rail.

Slide a spacer, arrow up, over the small round guide at the ends of each rail and install

the mounting screws finger tight.

Note:

Don’t tighten the mounting screws until you align the rails in the next step.

Expand the rails

so they fit inside

the rack posts.

Position the spacer

on the outside of the

post, and over the

threaded guide on the rail.

Position the spacer so the small

block on the back engages the

square hole in the rack support.

Use the screws that came

with the rail to secure the

spacer to the rail.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Sin comentarios

Apple Xserve (Early 2008) Manual de usuario Pagina 15