Apple Xserve (Early 2008) DIY Procedure for Processor Manual de usuario

 Xserve (Late 2006/Early 2008)073-1097 Rev. BProcessorReplacement InstructionsFollow the instructions in this document carefully. Failure to follow t

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 10Holding the processor by three corners only, keep the processor level as you place

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 11Note: When installing the processor on the logic board, align the processor notch

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 12Replacing the Processor Heat SinkHolding the heat sink by the slotted sides in one

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 13Replacing the Airow DuctLower the airow duct into position on the logic board. 1

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 14Closing the XserveReplace and secure the cover.1. Slide the Xserve back into the r

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 2Warning: Always shut down the Xserve before opening it to avoid damaging its intern

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 3Opening the XserveLoosen the thumbscrews at the back of the top cover and slide the

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 4Caution: Try not to completely remove the screws from the airow duct. Tiny black r

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 5Loosen the four screws securing the heat sink in the order indicated below. If two

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 6Caution: Whenever you handle the heat sink, handle it from the slotted sides, not t

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 7Caution: Each heat sink is connected to the logic board by a small 2-pin thermal se

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 8ProcessorRelease the latch on the metal processor holder.1. Rotate the top of the h

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 9Installing the Replacement ProcessorNote: You will need to apply new thermal grease