Apple Xserve (Early 2008) DIY Procedure for Drive Interc Manual de usuario descargar pdf (Pagina 10)

Xserve (Late 2006/Early 2008) Drive Interconnect Backplane Replacement Instructions 10

Tighten the thumbscrew that secures the backplane to the enclosure.4.

Reconnect the backplane-to-logic board I/O cable to the backplane.5.

Caution: Make sure the cable is completely seated.

Reconnect the front panel board cable to the front panel board.6.

Reconnect the power distribution board cable to the backplane and power distribution 7.

board.

Replacing the Fan Array

Align the power connector on the fan array with its connector on the power distribution 1.

board and lower the array into the enclosure. Push down on the fan array power connector

to make sure it is fully seated.

Tighten the screws at the ends of the array. Make sure the large front panel board cable runs 2.

above the power connector but below the tab on the top of the power supply.

Replacing the Airow Duct

Lower the airow duct into position on the logic board. 1.

Note: When installing the airow duct, be sure to route both the front panel board cable and

the backplane-to-logic board I/O cable inside the channel under the left side of the duct.

Ensure the airow duct ts ush all over, and does not protrude above the level of the 2.

enclosure.

Note: Be careful when working with any black foam pieces that are part of the airow duct

or the logic board.

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Apple Xserve (Early 2008) DIY Procedure for Drive Interc Manual de usuario Pagina 10