Apple LOGIC EXPRESS 7.2.1 Guía de instalación descargar pdf (Pagina 5)

Chapter 1: Hardware Connections and MC Client Setup 1

Chapter 1: Hardware Connections and

MC Client Setup

Schematics and parts are listed for each DAW setup in Appendix B, “DAW Parts Lists and Schematics.”

Connecting the MC

To connect the MC:

 Unpack the MC from its packaging and select a place to put it. The MC should go on a hard flat surface in order to allow proper

ventilation. (System 5-MC has its own frame for the MC and CM408T modules).

Use the following diagram as a guide to connecting the MC to its components.

1 VGA

2 Keyboard

3 USB

4 Talkback Mic Output

5 LAN

6 Footswitch

7 Headphone

8 DC In

 Plug the power supply into the DC In port on the right side as you look at the back panel. Be careful plugging this in as the con-

nector has pins that can be bent easily. When the pins are seated, twist the ring on the connector’s side until it locks. Do not turn

on the MC yet; network configuration must be completed first.

The MC and CM408T modules require sufficient ventilation space on the bottom. The MC has detachable feet for standalone

users without a System 5 frame, but the CM408T modules do not. If you do not use a System 5 frame, you must have at least

1 inch of clearance under the CM408T modules and MC or damage to the units may occur.

MC back panel

123 4 5 678

Attach the power supply to the MC before plugging it into an AC outlet, or the unit may be damaged.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Sin comentarios

Apple LOGIC EXPRESS 7.2.1 Guía de instalación Pagina 5