Apple Ethernet CS Twisted-Pair Card Guía de instalación descargar pdf (Pagina 14)

2-4 Installing Asanté MacCon Cards

MacCon-i NuBus Card

∆

Note: If you wish to disable link integrity, use the JP1

jumper on the MacCon NuBus card, as shown in Figure 2-

2. (For example, hubs made before the 10BaseT speciﬁca-

tions were published do not support link integrity.)

Figure 2-2

Disabling Link Integrity, MacCon-i NuBus card

Installing the MacCon NuBus Card

Power down the Macintosh. Disconnect and remove the

power cable.

Open the Macintosh.

Remove the access port cover. Make sure you are ground-

ed: check that your anti-static wrist strap is properly at-

tached to your wrist and to the Macintosh chassis.

Plug the MacCon card into the NuBus expansion slot on

the motherboard:

— With the card’s Ethernet connectors facing the expan-

sion slot access port, carefully line up the card’s edge

connector with the expansion slot (see Figure 2-3).

JP1

Link integrity disabled

JP1 jumper

Link integrity enabled

(default)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

Sin comentarios

Apple Ethernet CS Twisted-Pair Card Guía de instalación Pagina 14