Apple StyleWriter EtherTalk Adapter Especificaciones descargar pdf (Pagina 169)

Additional Procedures Default Settings - 46

Verifying Default Settings

Verify the logic board was reset to the “customer mode”.

Look at the NVM table at the bottom of the Extended

Diagnostic Page (shown on the preceding page). The first two

NVM addresses (upper left of the table) should display a

“00 00”. Also, on the first row, the last thirteen pairs of

numbers should read 43 6f 6c 6f 72 53 74 79 6c 65

57 72 69. If they read “ff”, then the incorrect version of

the Default Settings program is being used. The correct

version can be identified by the modification date on the file.

The correct file has a date of May 4, 1998.

Note: After replacing the logic board, carriage, or

mechanical assembly you must also use the Color SW 6500

X-Y Calibration utility to set factory default carriage values

in printer memory. Refer to the “X-Y Calibration”

procedure that follows.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 194 195

Sin comentarios

Apple StyleWriter EtherTalk Adapter Especificaciones Pagina 169