Apple Xserve (Blower Replacement) Manual de usuario

Busca en linea o descarga Manual de usuario para Ordenadores Apple Xserve (Blower Replacement). Apple Xserve (Blower Replacement) User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 5
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
073-0674 Rev. A
ð
Xserve
Blower
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
No tools are required for this procedure. You may, however, find a Phillips screwdriver
useful in releasing the thumbscrews at the front of the server.
Opening the Server
The server slides open from the front of the rack. The top cover remains in place in the
rack while the bottom housing (containing all internal components) should be placed on a
sturdy, flat surface.
1.Alert users that the server will be unavailable for a period of time.
2.Shut down the server.
Warning: To avoid damaging internal components or causing injury, always
shut down the server before opening it. After you shut down the server, internal
components can be very hot. Let the server cool down before continuing.
3.Write down the servers serial number, which is located on the back panel. If it is
necessary to set up the servers software after you replace the blower, you will be
asked for the serial number at login.
Vista de pagina 0
1 2 3 4 5

Indice de contenidos

Pagina 1 - Replacement Instructions

073-0674 Rev. A ð Xserve Blower Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these instructions coul

Pagina 2

Xserve Blower - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that came with th

Pagina 3

Xserve Blower - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2) 10. While dep

Pagina 4 - Removing the Installed Blower

Xserve Blower - 4 Removing the Installed Blower 1. Disconnect the blower cable from the drive interconnect board. (Figure 3) 2. Lift the blower str

Pagina 5 - Closing the Server

Xserve Blower - 5 Closing the Server 1. Carefully slide the bottom housing back into the rack.2. Tighten the front thumb screws to secure it. Warnin

Comentarios a estos manuales

Sin comentarios