Apple Workgroup Server 8550 Manual de usuario Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 121
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
On the internal/external bus, you can use SCSI ID numbers 0, 4, 5, 6. The
secondary hard disk (in the top bay of the internal disk drive bracket), the
optional built-in DAT drive (or any other drive in your servers auxiliary bay),
and the built-in CD-ROM drive reserve SCSI IDs 1, 2, and 3, respectively, on
the internal/external bus. If you do not have a secondary hard disk in the
internal disk drive bracket, you can also use SCSI ID 1 for this bus; if you do
not have a DAT or other drive in the auxiliary bay, you can use SCSI ID 2 on
this bus.
3 Locate the ID number switch on the back of your SCSI device.
4 Push the ID switch repeatedly until the number you want appears.
On some SCSI devices, the ID number switch is inside a small hole. Insert a
straightened paper clip to push the switch.
Follow the instructions in the next section to install an additional hard disk in
the internal disk drive bracket. To replace or install a drive in the servers
auxiliary bay, see “Installing a Drive in the Auxiliary Bay.” To connect
external devices to your server, see “Connecting an External SCSI Device.
SCSI ID switch
4
44 Chapter 3 / Expanding Your Server and Connecting Other Equipment
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 120 121

Comentarios a estos manuales

Sin comentarios